Haltech F10 User Manual download pdf (Page 28)

If you do not have a Hard Disk, go to the section titled Running the S oftware from the

Fl oppy Drive .

To install the software follow these step s.

Boot up Computer

Turn your PCs power on and boot up M S-DOS as instructed by the computers Users M anual.

If a shell program or menu utility runs automatically when you boot your computer, exit it

now. You should see something like this:

C:\>_

This is the ‘DOS Prompt’. It is DOS’ way of indicating that it is waiting for a command. The

C: indicates that the C drive is the drive currently selected. If you do not have a hard disk,

your promp t will probably look like this :

A:\>_

Select the Drive

To run the INSTALL program, you must insert the supplied disk in the disk drive. If the drive

is the A drive, then it must be currently selected. To select the A drive (or B drive if it is the

required drive) type :

Dy or %y

The y

y key is the Enter Key. On some keyboards it may be called the Return key. You should

now see the prompt :

A:\>_ or B:\>_

Run the INSTALL Program

To run the Install program type :

LQVWDOOy

The Install program will now run. Follow the instructions given. The program will suggest

that the software will be p laced in the HALTECH directory. You can change the destination

directory, but it is not recommended that you do unless you understand how directories work.

When it is finished, the installation p rogram will tell you if the installation is successful. If it

was not, consult the trouble shooting section of this manual.

The F10 Program is now ready to run.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 103 104

No comments

Haltech F10 User Manual Page 28