Haltech Platinum Interceptor User Manual download pdf (Page 14)

Interceptor Manual

The front-end software uses Com Port1 as the default communications port. Should there be a

need to select another com port, for example if the computer has no RS232 port and a virtual

USB RS232 port is being used, then the user can select the desired Com Port in the

Comms->Comms Setup menu. This needs to be done when the Haltech Interceptor is offline.

If the user needs to reset the Haltech Interceptor, for example after a setup change, the user can

select Comms->Reset ECU. The user will be prompted about the progress of the reset of the

interceptor in the status bar. Once complete the status bar will display "Interceptor Connected"

and the changes will be applied. Should the user need any further guidance then the user should

press F1 or select help from the menu.

1 2 ... 9 10 11 12 13 14 15 16 17

No comments

Haltech Platinum Interceptor User Manual Page 14