Haltech E6K User Manual download pdf (Page 65)

NOTE: If you ever wish to return the E6K to the factory barometric pressure

settings

then enable the Barometric Lock in the Fuel Set-up page and set the

Barometric Pressure Lock to 1013 mBars. These are the factory settings.

Method 3

Method 3 requires you to access the Fuel Set-up page and adjust two fields. Make sure the

Barometric Lock is Enabled. This tells the E6K that you are going to lock a particular value in

as the barometric pressure value. The next field down allows you to set a particular value.

This value should be the average barometric pressure the engine will be operated in. These

two fields are located at the bottom of the Fuel Set-up page:

Note that barometric pressure changes regularly and that Method 3 is only a basic approach at

barometric compensation. Set the Barometric Pressure Lock at xxxx mBars, where xxxx is the

pressure you require, say 1000mBars. When completed the E6K will assume that the

environment always operates at 1000mBars barometric pressure. It will then look at the

Barometric Correction Map located under the Maps pull down menu and locate the

1000mBars section of the correction map. Whatever the height of the bar corresponding to

1000mBars will be taken as the overall enrichment %.

For example, 1000mBars might correspond to the following highlighted bar on the

Barometric Correction Map:

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 153 154

No comments

Haltech E6K User Manual Page 65